Linea 2000 DO91771R Mode D'emploi page 33

PARTS
1. Freezer drawers
2. Levelling feet
3. Temperature control knob
INSTALLATION
· Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the
inside with a wet, lukewarm cloth. Dry the appliance off well.
· Let air circulate freely around the cabinet.
· This cooling unit is not intended for use as a built-in appliance.
· Select a place with a strong, level floor.
· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to form very quickly on the
evaporator, and your freezer.
· Before connecting your freezer to the power supply, check that the voltage stated on the rating label
of your appliance corresponds to the voltage in your home. A different voltage could damage the
appliance.
· After installation, leave the freezer for 24 hours before turning it on. This way the refrigerant can
settle.
· Allow the appliance to run empty for 12 hours so the compartment can cool to the appropriate
temperature.
www.domo-elektro.be
1
3
2
33
DO91771R