Vonyx AP1000ABT Manuel D'instructions page 4

170.344 REAR PANEL
Passive speaker output connector, minimum load 8 Ohm!
6 4
170.345 & 170.347 REAR PANEL
4
1. Jack ¼" input connector for microphone.
2. RCA line input connector for the audio input source e.g.
mixer, CD player, etc.
3. Volume control for the microphone.
4. Volume control for the line input.
5. Tone control.
6. Power ON/OFF LED indicator
light when the amplifier is turned on.
7. MP3/Line switch
52
1. Input connector for microphone.
2. Line input connector for the audio input source e.g. mixer,
CD player, etc.
3. Line output connector to a second box or amplifier.
4. MP3 volume control for MP3 Panel.
5. Volume control for the microphone
6. Volume control for the line input
7. Volume control for the speaker output.
8. Tone control.
9. Power ON/OFF LED indicator
light when the amplifier is turned on.
10. Clip LED Indicator. These LED will light up when amplifier
are on max power. It can occur that these LED will lit up
now and then, this is not a problem. But if it lights up
continually you need to adjust the volume down, otherwise
permanent damage to equipment might occur!
11. Passive speaker output connector (8Ohm)
This clear green indicator will
.
This clear green indicator will
.