Publicité
Les langues disponibles
Les langues disponibles
The tilt can be adjusted between 0° and 45° with two
distinct directions.
1. Unplug the power cord (12);
2. Loosen the fixing bolts and remove the cover of the base
plate (16);
3. Remove the dust port adaptor (13);
4. Loosen the fixing bolt of the base plate;
5. Adjust the base plate fixing teeth to the jigsaw ones
according to the desired tilt. Check the angle on the
scale (15);
0° - Vertical cut;
45° - Bevel cut (left and right);
6. Screw the base plate fixing bolt and assemble the
remaining parts in the reverse order of disassembly.
The parallel guide (2) is used to perform a parallel cut to
the end (edge) of the workpiece.
1. Loosen the parallel guide fixing bolts (2);
2. Set the guide according to the desired cutting width. The
cutting width value is shown by the base plate notch
(13), in the scale of the parallel guide rail (2);
3. Tighten the bolts.
1. Place the base plate (16) over the workpiece;
2. Press the ON/OFF switch (9) and the lock-on button (10)
simultaneously;
3. Let the blade reach its maximum speed. After that, direct
the blade towards the point you want to start cutting;
4. Apply a slight pressure over the jigsaw towards the
workpiece to avoid vibrations or the possibility of
breaking the blade;
5. Guide slowly the jigsaw so the saw blade can move along
the cutting line drawn on the workpiece the cut is
finished;
6. To turn the jigsaw off, release the ON/OFF switch.
The rotation speed can be adjusted using the speed dial (8).
The blade speed increases as you turn the dial and the
number visible on the dial increases.
The adjustment of the pendulum stroke of the blade is
controlled in the pendulum stroke selector (6) with 3
different positions (0, 1, 2 and 3).
▪ Position 0 – no pendulum movement:
- Cuts in hard materials (ceramics or steel) and thin
pieces (steel plate);
- Cuts in sharp edges.
▪ Position 1 – slight pendulum movement:
- Cuts in medium hard materials (for ex. hard wood or
plastic).
▪ Positions 2/3 - medium/intense pendulum movement:
- Soft materials (wood and plastic);
- Cuts in the direction of the fibres.
The best combination of blade speed and pendulum motion
depends on the material being cut. To determine the
optimum setting perform a test cut on a piece of waste.
Whenever you connect the jigsaw to a suction unit, keep the
blowing function button (14) in the "OFF" position.
When you want to use the blowing function, you cannot use
a suction unit.
Publicité
