Change Password; User Code Setting - Evolu7 Link Guide D'utilisation

Example: delete 1 defense zone of wireless magnetic contact in
defense from the host
Operation:【24】【01】【#】


Change password

1). Change user password
User password is the key to enter the system to operate host
disarm or remote control.
In Settings state, first enter address code [30] by host keypad,
then enter new four-digit password and finally press [#] to
confirm; voice prompts: set successfully, please enter
instruction.
Settings:【30】【XXXX】【#】
Example: change
Operation:【30】【1012】【#】
2).
Change Engineer password
The engineering password is the necessary key to enter
system for host function setting.
In setting state, first enter address code
the new four-digit password , and finally add the
confirm ; host " tick " a long sound , voice prompts " set
successfully " , the password successfully modified .
Operating
For example: change the password :2846 ;
Operation :
Note : The engineering password and user password can not
be set to the same four-digit number


User code setting

User code will
network the computer center.
XXXX: new four-digit password.
password :
[31]  [XXXX]  [#]
:
XXXX: the four-digit new password.
[31]  [ 2846 ]  [ # ]
identify each user's ID number when
1012
[31]
48
key , then enter
key to
[ # ]