Publicité
Les langues disponibles
Les langues disponibles
When attaching the doorbell button using the double sided tape, make sure the
surface of the door jamb or wall is clean.
The chime can be mounted by using the 3 holes in the back of the case, or by
using 2 screws with the keyholes.
Holes for
Wall Mount-
ing
Chime Back
Case Mounting
Snap the front of the chime case back on. Start with the top edge of the case
aligned with the top of the back plate.
Code and Tune Settings
Note: Most installations will not require you to change any of the jumpers
on your doorbell.
The doorbell button and chime communicate by using a code that can be
changed by removing and/or adding jumpers on both the doorbell button and
chime. The code is factory set; however, there are 128 selectable codes that
allow you to expand your system and prevent outside interference. Another
wireless doorbell system or other wireless products may cause interference
and the system may not function properly. Follow the instructions below for
setting a new code.
1. Disconnect the power to the doorbell button and chime.
2. Open the cases and locate the jumpers on both the doorbell button and
chime (See illustration).
All manuals and user guides at all-guides.com
Attach the back of the
case to the door jamb or
wall. Snap the front of the
button back on.
3-5/16"
(84 mm)
Chime Back Case
Keyhole Mounting
Code Settings
-2-
Close Chime Case
595-5611-06
Publicité
