Craftsman CMXPTSG1006NB Guide D'utilisation page 3

ENGLISH
1/4 in. Angle Die Grinder
CMXPTSG1006NB
Compressor requirements
™
4.5 @ 90
SCFM PSI
Tool Requirements
Exigences relatives aux outils
Requisitos de herramientas
Specifications
Model
Collet
Free Speed
Average Air Consumption
Air Inlet
Air Hose
Working Pressure
WARNING: Improper operation or maintenance of this tool could result in serious injury
and property damage. Read and understand all warnings and operation instructions before
using this tool. When using any tool, basic safety precautions should always be followed to
reduce the risk of personal injury. Anticipate and be alert for sudden changes in motion
during startup and operation of any power tool. Do not operate tool if trigger does not turn
the tool on or off. Do not use this tool at heights exceeding 6 feet (2m). Use each tool for its
intended function only. Do not use this product in unsafe work conditions. It is always
recommended to keep a fire extinguisher and first aid kit near work areas.
WARNING: User must also read the compressor manual and follow all compressor safety
instructions.
WARNING: Failure to observe and follow safety instructions could result in injury or death.
2
IMPORTANT: To operate correctly, this tool requires airflow that is at least 4.5 cubic feet per
minute (SCFM) at 90 pounds per square inch (PSI). Check the specifications of your air
compressor to be sure that it can support both the minimum SCFM and PSI required. The air
hose length could affect how much air pressure the tool is actually receiving. You may need to
adjust the air pressure higher on the air regulator to achieve the working pressure of 90 PSI.
CMXPTSG1006NB
1/4" (6.35 mm)
21,000 rpm
4.5 scfm
1/4" npt
3/8" (9.53 mm)
90 psi