LG DLGY1702 Serie Mode D'emploi page 19

Connecting Inlet Hose
The dryer must be connected to the cold water tap using the new water supply hose. Do not use old hoses
NOTE
are supplied with each inlet hose. They are used for
preventing water leaks. Make sure the connection to
the cold water tap is tight.
Short
hose
Y connector
WITH WASHER
a. Shut off the cold water tap and remove the washer hose.
b. Connect the short hose to the Y-connector using one
of the hose washers.
c. Connect the other end of the short hose to the cold
water faucet.
d. Connect the long dryer hose to one side of theY-connector
and connect the washer hose to the other side.
a. Connect the straight end of the long hose to the cold
water faucet.
NOTE
several gallons of water into a drain or bucket. This will
help prevent foreign particles such as sand and scale
from clogging the dryer inlet valve.
All manuals and user guides at all-guides.com
Hose
connector
Rubber
seal
Y connector
Long
hose
WITHOUT WASHER
INSTALLATION INSTRUCTIONS
pliers.
Make sure that there are no kinks in the hoses and that
they are not crushed.
hoses.
NOTE
remove the hose and check the condition of the
hose washer.
19