Publicité
Les langues disponibles
Les langues disponibles
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To remove the product from the
package
WARNING: Move the product from the pallet
carefully and safely. The product is heavy
and can cause serious injury if it falls.
•
Make sure that all items that is shown in the product
overview, are included. Refer to
right side on page 2 . Speak to your Husqvarna
dealer if an item is missing or damaged before you
move the product from the pallet.
•
Remove all package straps and wheel chocks.
•
Make sure that the area is clear and that you have
sufficient space to move the product.
•
Make sure that there is no risk that you or the
product can fall.
•
Use lifting equipment or ramps to move the product
from the pallet. The product is heavy. Move the
product safely. Refer to
23 .
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Put on necessary personal protective equipment.
Personal protective equipment on page 6 .
Refer to
3. Make sure that only approved persons are in the
work area.
4. Do daily maintenance. Refer to
schedule on page 17 .
5. Make sure that the product is assembled correctly
and is not damaged.
6. Put the product on the work area. Make sure that the
transportation of the product to and in the work area
is done safely and correctly. Refer to
on page 22 .
7. Make sure that there are diamond tools on the tool
plates and that the diamond tools and tool plates are
tightly attached.
8. Connect a dust extractor to the product. Refer to
connect a dust extractor on page 12 .
9. Adjust the handle and the handlebar to an applicable
operation height. Refer to
the handlebar on page 13 .
1253 - 002 - 24.10.2019
Operation
Product overview,
To lift the product on page
Maintenance
Transportation
To adjust the handle and
10. Make sure that the motor cable is connected to the
electrical enclosure before the product is connected
to a mains outlet. Refer to
grinding head on page 19 .
11. Connect the product to a power source. Refer to
connect the product to a power source on page 13 .
12. Turn the emergency stop button on the control panel
clockwise to make sure that the emergency stop
button is disengaged.
13. Make sure that you know the direction of rotation of
the grinding discs when you use direction diamond
tools such as Piranhas.
To engage and disengage the support
frame
The product has a support frame that is used to tilt the
product rearward. Also, the support frame is used as a
suspension device to hang the dust extractor hose and
the power cord on.
WARNING: Be careful when you move the
support frame. The moving parts can cause
injury.
To
To install and remove the
To
9
Publicité
