LENCO iPD-9000 DAB+ Mode D'emploi page 13

All manuals and user guides at all-guides.com
IPD9000 DAB+_IB draft R03 (1).pdf IPD9000 DAB+_IB draft R03 (1).pdf 2012-5-16 2012-5-16
Sleep to timer
This feature allows you to fall asleep to the CD, radio or iPod for up to 90 Minutes.
T he unit shuts off automatically when the time expires.
1. Press the STANDBY
2. Either tune to the desired FM or DAB radio station in radio mode, playback CD song or playback music
from the iPod.
3. To select the sleep timer to turn the unit off after 15, 30, 45, 60 or 90 minutes, press the SLEEP button
(from the remote control) repeatedly. The display shows the "SLEEP" indicator. The unit plays for the
selected length of time then automatically turns off.
4. To check the remaining sleep time, press the SLEEP button (from the remote control) once.
To turn the unit off before the sleep timer counts down to zero, press the STANDBY
Notes:
● If you are falling asleep to music from an external device connected to the AUX input, the sleep timer
will shut off the power to this system but it will not turn off the external device.
● If you activate the sleep timer while a CD is playing, the unit will only continue playing until the end of
the disc then shut off automatically no matter the sleep timer setting. For example, if your CD is only 30
minutes long and 45 minutes sleep timer is selected, the unit will shut off approximately 2 minutes after
the disc ends.
- Do not subject the unit to excessive force, shock, dust or extreme temperature.
- Do not tamper the internal components of the unit.
- Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
- Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
- Keep your unit away from heating appliances and sources of electrical noise such
as fluorescent lamps or motors.
If drop-outs or interruptions occur in the music during play, or if the disc fails to play
at all, its bottom surface may require cleaning.
B efore playing, wipe the disc from the center outwards with a good soft clean cloth.
Resetting the Unit
If the unit experiences a power surge or electric shock, it is possible that the internal micro-controller
may lock up and the unit will not respond to any commands from the panel controls.
1. In this event, unplug and then reconnect the AC power plug into the wall outlet.
2. Use a straightened paper clip, toothpick or similar objects to press the RESET button located at the rear
of the main unit (see the below figure). The reset operation clears the system memory and all of your
previous settings will be erased.
CAUTION: DO NOT USE SHARP, POINTED OBJECT TO PRESS THE RESET BUTTON.
IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT.
Note:
In case of malfunction due to electrostatic discharge (ESD), just reset the product to resume normal
●
operation.
The normal function of the product may be disturbed by Strong Electro Magnetic Interference. If so,
●
simply reset the product to resume normal operation. In case the function could not resume, please use
the product in other location.
21:31:29 21:27:54
Sleep Timer Function
button to turn the unit on.
Care and Maintenance
RESET Button
13
button at any time.