Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
SOLUTION:
Try all listed codes for the
device brands being set
up. Make sure they can be
operated with an infrared
remote control.
PROBLEM:
TV/VCR Combo does not
respond properly.
SOLUTION:
Use the VCR codes for your
brand. Some combo units
may require both a TV code
and a VCR code for full
operation.
PROBLEM:
Changing channels does
not work properly.
SOLUTION:
If the original remote
control required pressing
ENTER to change channels,
then press ENTER on the
remote control after
entering the channel
number.
PROBLEM:
During learning, LED
emits a long blink after
pressing and holding key
to be learned.
SOLUTION:
Memory is full or a bad
capture has occurred.
Avoid high-ambient light
sources, such as direct
daylight and fluorescent
bulbs. Try readjusting
positions of remote
controls before performing
the procedure again.
PROBLEM:
Tried Searching For Your
Code method and still
could not find a working
code.
O
WNER
SOLUTION:
Clear the device key as
follows: Press and hold SET
until the LED (red light)
blinks twice, then
release.Next enter 9 9 2.
Then press the device key
to be cleared twice.Now
repeat the Searching for
Your Code method on page
8.
PROBLEM:
CH+ and CH- do not work
for your RCA TV.
SOLUTION:
Due to RCA design (1983-
1987), only the original
remote control will operate
these functions.
PROBLEM:
No remote control of
volume.
SOLUTION:
See "Changing Volume
Lock" on page 14 to lock/
unlock volume.
PROBLEM:
If the above does not work.
SOLUTION:
Please contact us in any of
the following ways:
• Please visit:
www.oneforall.com
• If the above website is
not able to provide you
with the information
you need, please email
us at
ofasupport@ueic.com
and refer to
"Troubleshooting"
• Customer Support:
(330) 405-8516
Mon- Fri from 9AM to
5PM ET
Troubleshooting 17
'
M
S
ANUAL
Publicité
