Qstarz BT-Q1000XT Guide D'installation Rapide page 5

Beyond Navigation
................................................................................................................................................................................................................
4.3 GPS Log Setting
There are 4 log modes: General mode, vehicle mode,
cycling mode, and hiking mode. Users can also change the
default setting of these 4 modes.
4.4 Data Log Memory
Overwrite:
Stop Log:
4.5 Vibration Detector
Vibration Detector is functioned for power saving and
waypoint saving. It will detect the physical movement of
the device. When it detects the device not moving more
than 10 minutes, BT-Q1000XT/TR-Q1000XT will enter sleep
mode so that the Blue LED will turn to flash every 5
seconds. Under sleep mode the log will be disabled.
Note 1: Vibration Sensor function is turned off as default,
and can be turned on by provided software -> config GPS.
Note 2: Once the device enters sleep mode and it may
auto wake-up when detecting "significant" movement.
We strongly suggest you to use SHAKE method as first
priority to wake-up device in case some tracks might not
be recorded.
4.6 Speed Alarm
You can set the speed (0~999km/h) and continues for
(1~9999 secs) to enabled the speed alarm sound when
speed is exceeded.
Note: The speed alarm will not be functioned if the buzzer
function is disabled.
4.7 Time Schedule
................................................................................................................................................................................................................
www.Qstarz .com
All manuals and user guides at all-guides.com
When the memory is full, Travel Recorder will
keep logging by overwriting the memory
from the earliest point.
When the memory is full, Travel Recorder will
stop logging.
English
5