Ezviz T10 Guide De Démarrage Rapide page 8

Step 2 Setting the Alarm Water Level
1 Set the height of the adjustment pin with your hand or a screw driver to set the
alarm water level as desired.
The alarm water level is the height between the pin and the ground. When
water reaches the level, an alarm will be triggered.
The level ranges from 0.4 mm to 3.2 mm. The default level is 0.4 mm .
Choose a installation place, such as kitchen, balcony, or washroom.
2
• Place T10 at a place that with the water leak possibility.
• Do not place T10 at a place that is already immersed by water.
• Do not place T10 at a place that with busy passenger, in case it is kicked away.
• Do not place T10 at a place that is in corrosive or high-intensity magnetic environment.
• You are recommended to use T10 at a place that is smaller than 200m2. If the place is
Test T10 after you choose a place: Place T10 in water to trigger alarm, then T10
3
beeps for 15 seconds, if the connected Internet Alarm Hub receives the alarm and
issues an alarm voice prompt, the connection and installation is compelete.
All manuals and user guides at all-guides.com
too large, the communication between T10 and Internet Alarm Hub may be interrupted.
You can purchase several Internet Alarm Hub if you want to use T10 at a larger place.
0.4～3.2mm
3