BeeWi BBS010 Mode D'emploi page 6

6
All manuals and user guides at all-guides.com
2. USING THE PRODUCT
2.1. Car Installation
Insert the metal clip on the back of the speaker and clip it on driver's
car visor. make sure the speaker is firmly attached with the microphone
pointing towards the driver.
2.2. Charging
Prior to using the speaker the first time, it is recommended to fully charge
the battery. Normal full charge time is approximately 2 hours. The red LED
will stay on while charging and will be off as soon as it is completed.
ImPORTANT:
- Charging indication will be delayed by a few minutes if the speaker has
not been used for a long time or the battery is drained.
- To prolong battery life, it is recommended to charge the speaker as soon
as the low battery indicator is shown.
2.3. Power On / Power Off
Power On: press and hold the mFB button for 3 seconds until you hear
a short beep. The flashing blue LED light indicator comes on, and the
speakerphone automatically connects to the mobile phone it has been
paired with already.
Power Off: press and hold the mFB button for 3 seconds until you hear a
short beep. The flashing red LED light indication goes off.
2.4. Pair and connect
Refer to the Bluetooth pairing procedures in the mobile phone user ma-
nual.
When the speaker is off, long press the mFB button for about 5 seconds
until the light indicator flashes red and blue alternatively, then release
the button. The alternated flashes indicate that the speaker is in pairing
mode.
Search for Bluetooth devices in the phone, select "BeeWi BBS010" on
display and enter the pass key "0000" to add the speaker to the pair list.
When pairing is complete, the blue and red LED light will stop flashing,
and the speaker will automatically connect to the phone and go in standby
mode with the blue light flashing every 3 seconds.
ENGLISH