Electrical Connection - Maico EAQ 10/3 Instructions De Montage Et Mode D'emploi

gb | 5. Electrical connection

5. Electrical connection

NOTICE
Material damage if the incorrect voltage
is used.
This unit may only be supplied with safety
extra-low voltage (SELV)!
1. Lay a permanent cable to the
installation location. Permitted cable:
Type J-YSTY 0.6 – 0.8mm, 4-core.
Under certain circumstances, if using
the relay, at least 5-core.
2. Open the sensor housing: Use a
screwdriver or suitable object to press
(approx. 6 mm down) in the centre,
bottom housing slot to release the
inner locking clamp and tilt the bottom
part of the housing forwards.
10
3. Push through mounting holes and
produce marks on the wall intended
for installation. Note that the cable
entry must be at the top.
4. Use min. 2 screws to secure the
bottom part of housing to the
installation location. Suitable
mounting material is to be supplied by
the customer.
5. Connect the unit according to wiring
diagram, see sticker in the housing.
and slide on lower housing section
until you hear it engage.