Polaris 3900 Instructions D'installation page 5

6. Align the water management system and rear
housing assembly with the cleaner body (Figure
19). Ensure that the O-ring is still attached on the
pipe and it is not kinked or pinched (Figure 20).
Figure 19. Align water management system
Confirm the
O-ring is not
kinked or
pinched
Figure 20. O-ring seated correctly on feed pipe
7. Guide the water management system with rear
housing canopy attached into the feed pipe tube.
Push in firmly aligning the notches of the rear
housing into the lip of the top housing. Check that
the top housing lip is correctly aligned over the
rear housing (Figure 21).
All manuals and user guides at all-guides.com
|
Polaris 3900 Tune Up Kit Installation Instructions
®
ENGLISH
Check
for correct
alignment
Figure 21. Rear housing and top housing aligned
8. Replace three (3) water management system
screws (Figure 22).
1
Figure 22. Replace three (3) water management
system screws
9. Attach new bottom housing (gray) by replacing
three (3) recessed screws (Figure 23).
NOTE: Squeeze top and bottom housing pieces
together firmly as you tighten screws to ensure
both pieces remain aligned and create an even
seam in the cleaner body.
Page 5
2
3