Jabra LINK 14201-20 Guide De Démarrage Rapide page 10

To install your Jabra LINK solution
Settings:
1. Install your headset solution to your desk phone according to the
headset manual.
2. Set "Clear dial tone switch" in "A" position - see headset manual.
3. Ensure your headset base unit EHS mode is setup to RHL -
see headset manual*.
Connections:
4. With the cable included with your headset system, connect the
phone socket on your headset base unit to the headset socket on
your Toshiba phone.
5. With the cable marked purple
ring tone detector socket in the Jabra Link, and place the ring
sensor as close as possible to the ringer sound outlet on your
Toshiba phone. Some Toshiba Phones have the speaker placed in
the center of the ring socket, others have it placed at the bottom
of the socket, please modify the ring tone sensor accordingly to
ensure the best working environment.
6. With the cable marked red
headset base unit to the Jabra LINK AUX socket.
7. Pull out the headset from the base. You should now hear a dialtone.
8. Press the Multi-Function button on your headset. The phone should
now go onhook, and no dialtone is heard
9. Keeping the headset on, have a colleague give you a call. You
should hear a ringtone in the headset. Answer the call by pressing
the Multi-Function button on the headset.
Note: The marked end of each cable must be connected to the Jabra LINK.
All manuals and user guides at all-guides.com
, connect the 2,5 mm jack to the
, connect the AUX socket on your
11