Zeck d.a.i.sy DS 800 UHF Manuel D'utilisation page 30

All manuals and user guides at all-guides.com
3.4 Turning on the transmitter
The transmitter is turned on by sliding the on/off switch (3) into
As soon as the transmitter is turned on, it draws current from
its battery, regardless if an audio signal is applied or not.
3.5 Transmitter battery status LED (2)
A new transmitter battery causes the battery status LED (2) two flash only once
when the transmitter is turned on. As the battery capacity is used up, the LED
will flash more often when the transmitter is turned on (up to 5 times). More
than 3 LED flashes should be taken as a sign two change the battery.
1x
3.6 Carrier pouch
The supplied synthetic-leather pouch is designed to use the
transmitter on a belt or guitar strap. The pouch has access
holes for switch, battery LED and XLR connector. The pouch is
anchored by pulling its strap around the belt
or guitar strap and closing it (see illustration).
30
the dot-marked position. If a new battery is used, the red bat-
tery status LED (2) on the transmitter flashes only once. The
red „RF" LED (11) on the receiver must glow constantly,
provided that reception is hot disturbed.
full
5x
empty