Zeck d.a.i.sy DS 800 UHF Manuel D'utilisation page 25

All manuals and user guides at all-guides.com
2.3 Antennas
2.4 Output (17)
The receiver is equipped with a balanced 1/4" jack output (17)
with level adjustment control (19). Inserting an instrument
cable with a monaural 1/4" plug automatically switches the
output to unbalanced mode.
The receiver output level should be adjusted after the trans-
mitter input sensitivity (see chapter 4). The output level poten-
tiometer (19) should be set for unity system gain, which means
that the following audio device 'sees' the same level as if a cable were used.
2.5 On/Off switch (15)
The receiver is turned on and off with the headphone level con-
trol (15) which has an integrated switch. Turning the control
fully counterclockwise turns the receiver off. If the power
supply or battery is working and the unit is turned on, the
power indicator LED (24) will glow. A flashing battery
status LED (22) means that the transmitter is powered by a
weak battery. In this case, replace the battery or use the 12V=
power adaptor.
Before operating the receiver, both antennas have to
be screwed onto their sockets (26).
For best reception, both antennas have to be
aligned in a „V" pattern with an angle of 90 degre-
es between them. Always use both antennas to ensu-
re full diversity operation of the receiver.
ca. 90°
25