Black & Decker KA2000 Mode D'emploi page 8

ENGLISH
120 grit detailed finger
sanding sheet.
For a medium finish for
detailed sanding.
(Part Number - X3277-XJ)
Assembly
Warning! Before assembly, make sure that
the tool is switched o and unplugged.
Fitting sanding mesh (fig. A)
• Hold the tool with the sanding base
facing upwards.
• Place the sanding mesh (5) onto the
sanding base, making sure that the holes
in the sheet line up with the holes in the
base.
Fitting sanding sheets (fig. B -
Optional accessory)
• Detach the two additional
diamond-shaped tips (7) from the
sanding sheet (6).
The diamond-shaped tip (7) can be
reversed and replaced when worn.
• When the front part of the tip is worn,
detach it from the sheet, reverse it and
press it onto the sanding base again.
• When the whole tip is worn, remove it
from the sanding base and fit a new tip.
For optimal dust collection, ensure the
correct type of sanding paper is used.
Finger attachment (fig. C)
The finger attachment is used for fine detail
.
sanding
• Remove the screw (9).
• Remove the diamond-shaped tip (8)
from the sanding base.
• Fit the finger attachment (4) onto the
sanding base.
• Fit and tighten the screw.
8
All manuals and user guides at all-guides.com
(Original instructions)
• Fit the appropriate sanding sheet onto
Fitting and removing the dust
cassette (fig. D)
• Slide the dust cassette (2) onto the tool
• To remove the dust casette, pull it to the
Use
Warning! Let the 0tool work at its own pace.
Do not overload.
Switching on and o
• To switch the tool on, slide the on/off
• To switch the tool off, slide the on/off
Emptying the dust cassette (fig. D,
E & F)
The dust cassette should be emptied every
10 minutes of use.
• While holding the tool, pull the dust
• Remove the cassette lid (10).
• Shake the lid (10) and dust cassette (2) to
• Refit the lid (10) to the dust cassette (2).
• Refit the dust cassette (2).
Maintenance
Your tool has been designed to operate over
a long period of time with a minimum of
maintenance. Continuous satisfactory
operation depends upon proper tool care
and regular cleaning.
Warning! Before performing any
maintenance, switch o and unplug the tool.
• Regularly clean the ventilation slots in
the finger attachment.
and make sure that it is securely located.
rear and o the tool.
switch (1) to the forward position I.
switch (1) to the back position O.
cassette (2) off the tool.
empty the contents, the filter (11) inside
the lid (10) can be cleaned with a soft dry
brush.
your tool using a soft brush or dry cloth.