Beko SGA7126P Mode D'emploi page 12

4 Cleaning and care
4.2 Replacing the lime
collecting cartridge
A
WARNING: Do not use any
descaling agents! They may damage
the appliance.
WARNING: Do not purchase
cartridge from places other than
the dealers and service centers. If
A
you do this, the cartridge will not fit
into the cartridge slot and will not
operate. This causes a breakdown
in your appliance. Faults arising
from using wrong cartridge are not
covered under warranty.
1. " " symbol will flash on the control panel (10)
when the cartridge needs to be replaced.
C
The cartridge must be replaced after
consuming about 30 liters of water.
2. Soak the new cartridge in water for 1 minute in
order to enhance its performance.
3. Before removing the old cartridge from its slot,
make sure that the sections surrounding the
cartridge is cold.
4. Slightly press and release to replace the
cartridge.
2
5. Remove the new cartridge from its package,
soak it in the water for 1 minute and push it in
its slot.
12 / EN
All manuals and user guides at all-guides.com
4.3 Lime removing feature
(Self-Clean)
1. When the "
2. Fill the water reservoir (5) (see 3.6).
3. Plug in the appliance.
4. Hold and press the control button (11) and
C
5. Then press the control button (11) once.
1
6. Keep the appliance over the sink horizontally
7. When the lime removing (self-clean) is over, the
" lime removing (self-clean)
symbol flashes on the control panel, (10) this
means that it is time for lime removing.
steam trigger (12) together for 3 seconds.
3 sec.
The " " symbol will constantly
blink on the control panel (10) when
the appliance switches to lime
removing (self-clean) mode.
– " " symbol will flash on the control panel
(10) permanently.
and shake it while pressing and holding the
steam trigger (12).
appliance automatically returns to the mode
before the lime removing process.
Steam Station / User Manual