Keizer NUAGE PLS Notice D'utilisation page 41

Nuage
Given that the required seat width differs per
person, the Nuage PLS and the Nuage PLS
Active seating systems come as standard with
a split threshold cushion (C) made up of four
segments. The two outer segments and two inner
segments are kept together by a Velcro strip.
If required, an additional middle segment can
be ordered separately. The Nuage PLS Active
XS seating system comes with a single-piece
threshold cushion.
1. Determine the number of middle
segments to use:
S
#Middle- 1
segments
Seat width 30-40 cm
2. Attach the Velcro strap to the bottom side
of the cushion segments to hold them
together.
3. Loop a webbing strap (B) through the
slotted holes (H) and attach on the outside
of the seat shells with Velcro (figure 14).
4. Place the contour cushion on the seat, with
the rear of the cushion against (B).
5. Loop a webbing strap (B) over the top
of the cushion and through slotted holes
(I). Attach the strap on the outside of the
seat shells with Velcro.
6. Place a webbing strap (B) against the front
of the contour cushion and attach directly
on the outside of the seat shells with
Velcro.
Note!
Loosely tighten the straps (B) that hold the
contour cushion in place.
M L
2 3
40-50 cm > 50 cm
G
J1- J3
G
J1- J3
41
B