Alto Professional TSL115 Guide D'utilisation page 6

12. Light Mode: Turn this knob to select how the lights on the front panel function:
•
Mood: The lights will light up solidly.
•
Meter: The lights will simulate a digital volume meter. Lower-level signals trigger
only the bottom lights. Higher-level signals trigger all lights.
•
Mix: The lights will light up according to the frequency spectrum of the audio signal.
Bass frequencies will produce more red light. Mid-range frequencies will produce
more green light. Treble frequencies will produce more blue light.
•
Pulse: The audio signal will cause the lights to pulse with one color (determined by
the Color Select knob) with their brightness determined by the Brightness knob.
•
Party: When the Color Select knob is fully counterclockwise, the LEDs cycle rapidly
through a pre-programmed dynamic show of colors and meter levels. Turn the
Color Select knob clockwise from this position to change to a slower continuous
cycle of solid colors. Turn the Color Select knob further clockwise to slow down
how quickly the colors change.
To turn the lights off, turn the Brightness knob to its counterclockwise-most position.
13. Color Select: Turn this knob to set the color of the lights on the front panel. The color of
the front-panel lights and the Color Preview LED will change as you turn it.
Note: This knob affects the color in Mood, Meter, and Pulse modes only. It has a
different function in Party mode.
14. Color Preview LED: This light is the same color as the lights on the front panel. You can
turn the Color Select knob to change it.
15. Brightness: Turn this knob to set the brightness of the lights on the front panel. To turn
the lights off, turn this knob to its counterclockwise-most position.
6