Miles Industries Valor 555CFK Directives D'installation

INSTALLATION AND OPERATING INSTRUCTIONS
555CFK Circulating Fan Kit
CSA approved for use only with:
Valor models 530 I, Retrofi re RF24DV and Madrona MF28
Note: This kit must be installed or serviced by a qualifi ed installer, service agency or the gas
supplier. These instructions are to be used in conjunction with the main installation instructions for
the above listed models.
WARNING: If the information in these instructions is not followed exactly, a fi re or explosion
may result causing property damage, personal injury or loss of life.
GROUNDING: This power supply must be installed and grounded in accordance with local codes,
or in the absence of local codes, with the current Canadian Electrical Code CSA C22.1. or in the
USA the National Electrical Code ANSI/NFPA70 latest edition.
Description of System
The models listed above have been designed to
accommodate the installation of an air circulation fan.
Operated by a variable speed control and a thermally
actuated switch, the fan is designed to boost the
natural convection through the heater; this may be a
desirable feature dependent on the fi replace location
and room layout.
The circulating fan may be installed before the heater
installation or as a retrofi t at a later date.
Operation
The fan is designed for automatic operation using a
thermal switch. It will take approximately 10-15 minutes
for the appliance to warm up and allow the switch to
activate the fan.
To operate the fan, rotate the speed control knob
clockwise from OFF to HIGH. Further rotation will
control the fan speed, once the automatic thermal
switch has been activated.
If the fi re is turned off , the fan will continue to operate
until the thermal switch cools, unless the speed control
is manually turned to the OFF position.
Should electrical power fail, the heater operation
will remain unaff ected.
4000510-06
All manuals and user guides at all-guides.com
Electrical Requirements
The fan kit requires a power supply of 120 Volts,
1 phase, 60 Hz. Full load current is less than 1 amp.
AND OPERATING INSTRUCTIONS
© 2018, Miles Industries Ltd.
PLEASE LEAVE INSTALLATION
WITH THE HOMEOWNER.
1