Télécharger Imprimer la page

Danby DCF070A1BDB Guide D'utilisation Et Soins De Propriètaire page 3

Publicité

Les langues disponibles

Les langues disponibles

Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electrical shock by providing an escape wire for the electrical current.
ELECTRICAL
REQUIREMENTS
GROUNDING
INSTRUCTIONS
Installation Instructions
LOCATION
ELECTRICAL RATING: The "serial rating plate" indicates the volt-
age and frequency the freezer is designed for.
Due to possible variations in line voltage (caused by overloading of cir-
cuits), it is advisable to install a separate fuse circuit from the meter
panel. This will help to eliminate current fluctuation which might cause
motor trouble.
IMPORTANT WARNING: An empty refrigerator is a very dangerous
attraction to children. Remove either the gasket or lid from unused appli-
ances, or take some other action that will guarantee it harmless.
DANGER:
Risk off child entrapment. Before you throw away your old
refrigerator or freezer:
• Take off the doors.
• Leave the shelves in place so that children may not easily climb in.
DON'T WAIT DO IT NOW!
This appliance must be grounded. In the event of an electrical short cir-
cuit, grounding reduces the risk of electrical shock by providing an escape
wire for the electrical current.
This appliance is equipped with a cord having a grounding wire with a
grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded.
DO NOT USE AN EXTENSION CORD. Use an exclusive wall outlet. Do
not connect your freezer to extension cords or together with any other
appliance in the same wall outlet. Do not splice the cord.
Remove exterior and interior packaging, wipe the outside thoroughly with
a soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing
the unit in a narrow recess or near any heat source, direct sunlight, or
moisture. Let air circulate freely around the unit. Keep the rear of the
freezer 5 inches away from the wall.
1) Locate the freezer in such a manner that extension cords are not
necessary.
2) Due to lid and hinge arrangement, it is impossible to install your freezer
directly against the wall. The spacing on the back is essential for
maintaining proper air circulation around the freezer.
3) Select a location with reasonable year round temperatures. We do not
recommend operating the freezer when surrounding air temperature is
below 0°C (32°F), though it will not harm the freezer to stand in any
temperature below 0°C (32°F), provided the temperature control is set
to avoid running the unit. In order to keep operating cost down, do not
place freezer near a stove, furnace, heat register or in direct sunlight. If
the place selected for your freezer is damp or moist, as in basements,
place freezer on wooden blocks (two or three 2x4's under entire length
will ensure adequate support).
2
WARNING

Publicité

loading