Black & Decker PRO Serie Mode D'emploi page 4

ENGLISH
4. Power tool use and care
a. Do not force the power tool. Use the correct power
tool for your application. The correct power tool will do
the job better and safer at the rate for which it was
designed.
b. Do not use the power tool if the switch does not turn
it on and off. Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c. Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools. Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
e. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc. in
accordance with these instructions, taking into
account the working conditions and the work to be
performed. Use of the power tool for operations different
from those intended could result in a hazardous
situation.
5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
SAFETY INSTRUCTIONS FOR CUTTING OFF
OPERATIONS CUT-OFF MACHINE SAFETY
WARNINGS
a) The guard provided with the tool must be securely
attached to the power tool and positioned for
maximum safety, so the least amount of wheel is
4
All manuals and user guides at all-guides.com
b) Use only diamond cut-off wheels for your power tool.
NOTE: Use the wording "diamond" as applicable depending
on the designation of the tool.
c) The rated speed of the accessory must be at least
d) Wheels must be used only for recommended
e) Always use undamaged wheel flanges that are of
f) Do not use worn down reinforced wheels from larger
g) The outside diameter and the thickness of your
h) The arbour size of wheels and flanges must properly
i) Do not use damaged wheels. Before each use,
exposed towards the operator. Position yourself and
bystanders away from the plane of the rotating wheel.
The guard helps to protect operator from broken wheel
fragments and accidental contact with wheel.
Just because an accessory can be attached to your
power tool, it does not assure safe operation.
equal to the maximum speed marked on the power
tool. Accessories running faster than their rated speed
can break and fly apart.
applications. For example: do not grind with the side
of cut-off wheel. Cut-off wheels are intended for
peripheral grinding, side forces applied to these wheels
may cause them to shatter.
correct diameter for your selected wheel. Proper
wheel flanges support the wheel thus reducing the
possibility of wheel breakage.
power tools. Wheels intended for a larger power tool are
not suitable for the higher speed of a smaller tool and
may burst.
accessory must be within the capacity rating of your
power tool. Incorrectly sized accessories cannot be
adequately guarded or controlled.
fit the spindle of the power tool. Wheels and flanges
with arbour holes that do not match the mounting
hardware of the power tool will run out of balance, vibrate
excessively and may cause loss of control.
inspect the wheels for chips and cracks. If power tool
or wheel is dropped, inspect for damage or install an
undamaged wheel. After inspecting and installing the
wheel, position yourself and bystanders away from
the plane of the rotating wheel and run the power tool
at maximum no load speed for one minute. Damaged
wheels will normally break apart during this test time.