Publicité
Les langues disponibles
Les langues disponibles
1b. Choose drawer mounting location. Place Phillips
head screwdriver on perforated metal punchout
hole. Hold screwdriver firmly in place. Using a
hammer, tap the handle end of the screwdriver until
the metal perforation is removed. This will allow you
to fasten the screw to the channel assembly in
step 2. (See Figure 1b)
NOTE: Mounting locations must have pre-drilled
holes located 22⁄" apart to accommodate
drawer.
Figure 1b
Leg Channel
Assemblies
2. Mount poly slides to predrilled holes in leg channel
assemblies. Secure with four 1" screws using Phillips
head screwdriver. (See Figure 2)
NOTE: Some tables may come with bolts
pre-threaded in leg channels. If so, re-use
these to attach poly slides.
Figure 2
Leg Channel
Screw
Poly Slide (left)
PAGE 2 OF 6
ASSEMBLY CONTINUED
Table (underneath)
Poly Slide (right)
1-800-295-5510
3. Center drawer stop between poly slides on front
leg channel. Using electric drill and two supplied
#8 x 1/2" drill screws, attach drawer stop to leg
channel. (See Figure 3)
NOTE: Holes for mounting drawer stop are not
pre-drilled.
Figure 3
Drill Screws
4. Mount drawer to poly slides. (See Figure 4)
NOTE: Drawer has a 20 lb. weight capacity.
Figure 4
Poly Slide
(left)
uline.com
Front Leg Channel
Drawer Stop
Tabletop
Drawer
Poly Slide
(right)
1222 IH-6262
Publicité
