Publicité
Les langues disponibles
Les langues disponibles
3. Product Description
(1) Sensor Cover
(2) Soft Sensor Tip
(3) Readout Display
(4) Start Button
(5) ON/OFF Button
(6) Battery Cover
(7) Senser Cover
Applicator
(8) Protective
Storage Cap
4. How the KAZ
Ear Thermometer Measures Ear Temperature
®
The KAZ Ear Thermometer measures infrared energy radiated from the
eardrum and the surrounding tissue. This energy is collected through
the sensing lens and converted to a temperature value. The measured
reading obtained directly from the eardrum (Tympanic Membrane) can
ensure the most accurate ear temperature. Measurements taken from
the surrounding tissue of the ear canal generate lower readings and
may result in misdiagnosis of a fever.
To avoid an inaccurate measurement:
• Use KAZ sensor covers. The unit is calibrated to work with sensor covers.
• Straighten the ear canal by gently pulling the middle of the ear back and up. Pull the ear
straightback for newborns to age 1.
• Place the sensor firmly into the ear canal. Press the Start button and keep the sensor in the
ear until the thermometer beeps to indicate completion of the measurement.
The KAZ Ear Thermometer has been clinically tested to meet ASTM standard E-1065
as pertains to infrared thermometers. It is proven to be safe and accurate when used
in accordance with this operating instruction manual.
All manuals and user guides at all-guides.com
(2)
(3)
(4)
(5)
(7)
(8)
(6)
6
5. How to Read the Display
Display
Display Meaning
Self-check ensures proper
functioning.
Recall of last reading.
Ready to measure.
Measurement complete.
Low battery indication.
Unit will not take accurate mea-
surements.
6. How to Apply a New Sensor Cover
(1) Remove protective cap from thermometer.
Pull sensor cover into position over the hole in
the top of dispenser.
(3) Completely push the tip into the
sensor cover holder hole. Push firmly.
NOTE:
• Unit is calibrated to work with sensor covers. Only use of KAZ sensor covers ensures accura-
cy and hygienic use.
• In order to avoid spreading germs, please use a new sensor cover for each measurement.
• Check to ensure sensor cover is fitted on firmly before use. If the sensor cover is broken, dis-
card and apply a new one immediately.
• Failure to use sensor covers each time will result in low, misreadings.
Description
Press the ON/OFF button to turn
on the unit. All icons will be
shown for 2 seconds.
The last reading will be shown
on the display automatically for
3 seconds.
The unit beeps once and the
°F icon will keep flashing.
The reading will be shown on
the LCD display. When the °F
starts to flash the unit is ready
for next temperature.
The battery icon will flash when
the unit is on to alert you to
replace the batteries.
(2) With Protective Cap off, push the thermometer
vertically into the center part of the sensor
cover.
(4) After feeling a slight click, take out the sensor
with cover attached tightly.
7
Publicité
