Publicité
Les langues disponibles
Les langues disponibles
To change battery just remove bottom front screw, remove unit, change battery, and replace unit back in bracket.
3. Mount the wired magnetic sensor to the door/gate/window frame, and the other sensor to the edge of the
door/gate/window by using the double sided tape provided (Fig.5)(make sure surface to be mounted on is clean before
installing) The two sensor arrows must be facing each other, aligned and no more than 1/4" apart. Otherwise you may get
false triggers.(Fig. 6)
4. Nylon tie wraps are provided (Fig.7) to install unit on gate.
HOW TO USE
1. Change factory default pass code of 123. (3 digits only)
a. Make sure the unit is in OFF/DISARM mode.
Press and hold the [1] key for 2 seconds, the unit will BEEP. Release. You are now in
b.
mode.
c. Enter old pass‐code, the unit will sound two Beeps (if wrong number entered the unit will make a DU
sound). Enter your new password; the unit will sound three Beeps to let you know the change was
successful. If unit does not beep three times restart from step [a].
d. If you forget your password, take battery out for a full two minutes and unit will reset to factory
default of 123.
To ARM, DISARM and use the BY‐PASS.
Arming the system: Enter your pass code then press [ON/OFF], the unit will BEEP three times after 3
seconds. The unit will be armed and the LED will flash once every three seconds. Anyone opening the
DOOR/WINDOW/GATE without first entering the pass code will trigger the unit and the alarm will sound for 10
seconds and cycle on and off every 10 seconds. Even if the door is reclosed, once the alarm has been triggered, the
unit must be disarmed or set to BY‐PASS to stop the alarm.
All manuals and user guides at all-guides.com
pass code change
Publicité
