Publicité
Les langues disponibles
Les langues disponibles
FUNCTION
When the system is armed, if the door or gate is opened, a 105dB loud alarm will sound for 10 seconds, then cycle on and off at 10
second intervals. In order to stop the alarm you must enter your pass code and press the on/off button to disarm the system.
Pressing the pass code and BY‐PASS will provide you with 15 seconds to open the door without sounding the alarm. The alarm will
reset itself automatically within 5 seconds after the door is re‐closed when the by‐pass feature is used. When activated, the alarm
will sound (for 10 seconds at 10 second intervals) until the unit is disarmed, or until the batteries are dead.
DESCRIPTION OF SYSTEM
1. Keys:
a. [ON/OFF]: press to arm/disarm the system.
b. [BYPASS]: press to delay alarm for 10 seconds.
c. Pass code digits: 1, 2, and 3
2. LED: Low Battery indicator and system armed indicator.
Flashing once per second indicates low battery.
Flashing 3 times per second indicates the system is alarming (ringing);
Flashing once every 3 seconds indicates the system is armed.
3. Magnetic sensor: detects whether door/gate is open or closed.
SPECIFICATIONS
Internal power supply: 9V alkaline battery included.
Battery Life: In standby mode, approximately 1 year.
Operation temperature: ‐10
Operation humidity: <80%.
Storage temperature: ‐20
INSTALLATION AND OPERATION
BATTERY INSTALLATION
1. Remove bracket (Fig1), open the battery cover (Fig2), install 9V alkaline battery supplied (Fig3).
2. Once the battery is installed the system will sound a beep, indicating the battery was installed correctly. Replace battery
cover but not the bracket, go to next step.
INSTALLATION OF SYSTEM
1. Choose location for the installation. The control unit should be installed at a minimum height of 54", but high enough to
avoid the reach of young children. Make sure the sensor wire is long enough to reach between the main unit location and
the edge of the gate/door/window.
2. Installing the bracket: using template provided to mark drill holes. Using a 1/4" drill bit, drill holes, insert plugs (may need
to use a hammer to gently tap in the plugs for a tight fit), then place bracket over plugs and using screws provided to
secure bracket, sliding bracket down on screws for a snug fit.(Fig.4) Place the unit into bracket and install front screw.
All manuals and user guides at all-guides.com
0
0
~ to +40
C. (14 – 104 F)
0
0
C ~ +60
C ( ‐4 – 140 F)
Publicité
