Publicité
Les langues disponibles
Les langues disponibles
THE CHANNEL
Input assign switches: These switches allow to choose which of the following backpanel inputs
will be audible:
Phono (turntable MM cartridge) or CD or Line (CD and Line inputs are same characteristics).
At channel 1 we also have a Mic input.
Gain Control: Allows the adjustment of the channel input sensitivity regarding the different
source levels. Each channel has an optical check up by means of the 10 LED bargraphs of the
level meter.
Channel EQ: Independent control is provided for the high (13KHz), the mid (1KHz) and the
low (70Hz) frequency band. Please be aware, that any boosted frequency band will increase the
total level and decrease the level headroom.
Channel level meter: The meter display the channel level before channel fader. To set the
channel at the right level, when in play back, set the Gain in a way that all green Leds light and the
yellow and red only blink.
Headphones assign switch (Cue): With these switches you can assign any of the input channels
to be replayed on the headphones. Please note that you can only hear the required source if the
input assign switch is switched to the respective position and the source is in play mode.
Channel fader: By means of these controls, you determine the part of the overall level, that a
specific channel contributes. Please be aware of the final output level to be adjusted by the
Master and Booth controls. Furthermore, the level of the channels can depend on the setting of
the Crossfader if these channels are assigned to it by means of the Crossfader assign control. To
be in-field replaceable, this part is front-detachable. For replacement, switch off the unit and
unscrew the 2 outer screws of the crossfader and remove the part; detach the connector and
replace the part. Plug in the connector and screw the new part to the main body again.
See page 25.
Crossfader & Kill selector: By means of this control we can send the channel signal to:
-A:Crossfader Left.
-B: Crossfader Right.
-Bypass: Send channel signal strait to Master Bus
Reverse: Reverses the inputs right and left to the crossfader.
When in reverse mode a Led will light.
2
All manuals and user guides at all-guides.com
Crossfader: Under the precondition of opened channel faders of those channels being
routed to the crossfader, you can crossfade between these two input channels.
dB
9
6
3
0
3
5
7
10
15
20
10
9
8
7
6
5
4
3
2
1
0
Boost: Increases 6 dB the level of low level frequencies
(100Hz). Use it to enhance the Beat.
CD
LINE
PHONO
GAIN
HIGH
26 dB
12 dB
+
MID
eq
26 dB
+
12 dB
LOW
26 dB
12 dB
+
cue
cue
A
BYPASS
B
Publicité
