Samsung Jet Bot VR30T85 Serie Manuel D'utilisation page 12

Safety information
• Make sure there are no dangerous objects
around the Jet Bot's cleaning area to
prevent collision and unplug any electric
heaters or fans.
- The Jet Bot can be damaged or
malfunction.
• The Jet Bot is intended for household
use therefore do not use it in an attic,
basement, storage, an industrial building,
out of indoor space, places with moisture
(such as a bathroom, a laundry room), on
the table or shelves.
- The Jet Bot can be damaged or
malfunction.
• Attach the Boundary Markers to a place
where the Jet Bot may fall such as a stair
or a banister to prevent product damage
and injury.
- Please keep the Cliff Sensor clean all the
time for safety.
• Be sure the Jet Bot does not suck in or
touch any kind of liquids (water, beverage,
filth, etc.).
- The Jet Bot can be severely damaged
and it may contaminate other areas if the
wheels pass through liquid.
• Do not spill any liquids on the Clean Station.
- There is a risk of fire or electric shock.
• Do not use the Clean Station for anything
other than its intended purposes.
- There is a risk of fire or severe damage to
the Clean Station.
• Always keep the Cliff Sensor clean for your
safety.
• As this wireless installation may cause
radio interference, it cannot provide a
service related with human safety.
12 English
CAUTION
• Insert the Dustbin before using the Jet Bot.
• When installing the Clean Station, do not
leave the cord carelessly on the floor since
the Jet Bot may get tangled by it.
• To clean all areas of your house, open all
rooms and set the No-go Zones with the
SmartThings App or attach the Boundary
Markers to the places where the Jet Bot
may get damaged such as a front door, a
veranda, a bathroom, and stairs for safety.
• Follow these recommendations for proper
automatic recharging.
- Always turn on the power of the Clean
Station.
- Install the Clean Station where the Jet Bot
can easily find.
- Do not leave any objects in front of the
Clean Station.
• Do not use the Jet Bot on black colored
floors.
- The Jet Bot may not be able to operate
normally.
• Do not place any objects within 0.5 m of
either side of the Clean Station or within
1 m of the front of the Clean Station.
• Make sure the Clean Station's charging
contact is not damaged or have any foreign
matter on it.
• For the very low areas where the Jet Bot
may get stuck, set the No-go Zones with the
SmartThings App or attach the Boundary
Markers to prevent the Jet Bot from getting
in.
• Do not install the Clean Station in an area
with a dark floor.
- If the floor around the Clean Station is
dark, recharging is hindered.
• Move any obstacles that may disturb the
Jet Bot's movement (such as children's
indoor swing or slides) before cleaning.
• Do not use the Jet Bot in a place which is
narrower than its turning radius 0.5 m or
less.