Hendi H90 Mode D'emploi page 8

RESET with the SAFETY CUT-OUT
Please note that there is a SAFETY CUT-OUT device
for protection located at the lower rear side of the
appliance with a protective cap. This is to turn off
the appliance automatically when the temperature
is too high.
• Unplug the appliance from the electrical outlet
first.
Cleaning and Maintenance
Warning!
• Always disconnect the appliance and open the
door to allow it to cool down completely before
cleaning.
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
• Avoid the use of sprays as this may damage the
appliance's surface.
Parts
All accessories such as trays, tray
handle, tray holders
EN
External housing
Inside of the appliance
Glass door
Storage
• Always make sure the appliance has already
been disconnected from the electrical wall outlet
and cooled down completely.
Troubleshooting
If the appliance does not function properly, please
check the below table for the solution.
Problem
When connected to the electrical
power outlet, the control settings are
made & indicator lights are on. But the
appliance does not heat up.
When connected to the electrical
power outlet, the control settings are
made. It heats up normally. But the
indicator is not on.
Neither the indicator nor the heating
element works.
8
All manuals and user guides at all-guides.com
How to clean
- Soak in warm, soapy water for about 10 to
20 minutes
- Rinse under running water thoroughly.
- Wipe clean with a soft cloth and a little mild
detergent. Make sure no water or moisture
enters inside of the appliance.
- Remove any food deposits.
- Wipe with a damp cloth and a little cleaning
detergent to remove any spills or splatters.
- Note: Be sure not to damage the heating
elements.
Possible cause
The thermostat is defeated
At least one of the heating element is
burnt out.
The indicator light is defective.
The power cord & plug is not connect-
ed firmly with the electrical power
socket.
• Allow the appliance to completely cool down.
• Unscrew (tool not supplied) the black protective
cap of the "SAFETY CUT-OUT".
• Push the button to RE-SET the overload circuit.
You should hear a click sound.
• Screw back the protective cap on the "SAFETY
CUT-OUT" button.
• The appliance should be cleaned regularly and
any food deposits removed.
• Wipe out any remaining oil or fat.
• Note: The trays holder on two sides can be un-
screwed (tools not supplied) to detach for clean-
ing.
Remark
Dry all parts well at last.
• Store the appliance in a cool and clean place.
If you are unable to solve the problem, please con-
tact the supplier/service provider.
Possible solution
Take the appliance to your supplier or
service provider for repair.
Take the appliance to your supplier or
service provider for repair.
Check again the connection. And
make sure all the connections are
firmly connected.