Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The identifiers (
,
, etc.) shown here refer to the identifiers used in the Quick Manual. Refer to the Quick Manual.
Transmitter (YIT-W11TX or YIT-W11TX-A)
Connects an iPhone/iPod. When the iPhone/iPod is connected, the speaker unit turns on.
To listen to music through the speaker unit, begin playback on the iPhone/iPod.
The iPhone/iPod can be connected or disconnected anytime. When the iPhone/iPod is disconnected from the transmitter, the
speaker unit remembers the volume level. When the iPhone/iPod is connected again, the volume is set at the same level.
Notes
·
If your iPhone/iPod is in a protective case, remove the case before connecting the iPhone/iPod. The connector
could be damaged if you try to forcefully connect the iPhone/iPod while it is in a protective case.
·
The transmitter operates using the power of the iPhone/iPod battery. Because the power of the iPhone/iPod
battery may decrease quicker than usual, charge the battery often.
When a telephone call is received by the iPhone during playback, the playback stops automatically. The playback
resumes once the telephone call is finished.
Charging Cradle (YIT-W11BC)
Charges the battery of the iPhone/iPod that is connected to the transmitter.
Group Selection Switches
Use these switches to change the group setting for both the speaker unit and the transmitter. To connect the speaker unit and
transmitter wirelessly, set them to the same group.
To switch the groups, refer to the Quick Manual.
Note When using the speaker unit, set the transmitter to group A. Use group B when controlling another yAired device.
You can control up to 7 yAired devices using a transmitter when they are set to the same group.
5V
(AC Adaptor)
Connects the AC adaptor (for the charging cradle).
AUX
Connects an external device. When the external device is connected, the speaker unit turns on.
To listen to music through the speaker unit, begin playback on the external device.
To connect an external device to the speaker unit, use a commercially available 3.5 mm (1/8 in) stereo mini plug cable.
Note When disconnecting the external device, be sure to remove the cable from AUX. Otherwise, the speaker unit will
remain on while the cable is connected.
15V
(AC Adaptor)
Connects the AC adaptor (for the speaker unit).
/
(Volume keys)
Adjust the volume level.
·
If the volume was set at a high level when the iPhone/iPod or external device was disconnected, the volume may be
lowered automatically when playback begins.
·
When the AC adaptor (for the speaker unit) is disconnected, the volume level is reset to the default volume level.
·
When controlling yAired devices using a transmitter, the volume is adjusted as follows.
‑
When the volume level is adjusted using the iPhone/iPod, the volume levels of all of the yAired devices change.
‑
When the volume level is adjusted using one of the yAired devices, only the volume level of that device changes.
·
When an iPhone/iPod and external device are connected and playing at the same time, the volume is adjusted as follows.
‑
When the volume level is adjusted using the iPhone/iPod, the volume levels of both the iPhone/iPod and external
device change.
‑
When the volume level is adjusted using the external device, only the volume level of the device changes.
3
En
CONTROLS AND OPERATIONS
Publicité
Table des Matières
