Publicité
Les langues disponibles
Les langues disponibles
4.4- Electrical speed regulator
The speed regulator (7) is located on the inside of the handle (Fig. 6). It allows you to vary the speed
of the machine. Always reduce speed when placing or removing the mixing paddle in the material.
Once the mixing paddle (6) is completely free of the mixing material, increase the speed again so that
the motor is sufficiently cooled.
V. OPERATION
5.1- Intended use:
- The product is intended for domestic use indoors or under shelter.
- The product is intended for mixing paint, lacquer, mortar...
- Do not use tool for any other use outside the scope of this manual.
5.2- Operation:
1. Connect product to power source (see characteristics on product)
2. Wear appropriate protective equipment
3. Prepare material for mixing
4. Tightly secure the mixing container
Do not use your own weight or body to hold the container.
5. Firmly hold mixer with both hands. Always maintain a balanced and secure position.
6. Place mixing blade in material. Do not make any sudden movement or pendulum movement
7. Press on the lock button then on the switch to start mixer.
You can adjust speed with the speed selector.
8. Once work is finished, stop mixer by releasing the switch.
Note: do not put down the mixer until the mixing blade comes to a complete stop.
VI. MAINTENANCE AND STORAGE
Before any intervention on product, ensure that switch is set on the "OFF"
position and plug removed from socket outlet.
Reminder: Make sure to maintain the machine in good working condition, carry out regular maintenance of the
machine after each use and before storage .Any breach or default of adequate maintenance reduces the life of the
machine and increases the risk of breakdowns and accidents.
To preserve the security system throughout the life of the machine, it is important to perform maintenance and proper
cleaning, DO NOT use non-compliant replacement parts and do NOT dismantle yourself the machine or change the
security features.
6.1- Maintenance
a) Clean the plastic parts with a soft and clean cloth.
Do not use aggressive cleansing agents (solvents, abrasive cleansers) or an abrasive sponge or any
sharp objects.
Fig. 6
Publicité
