bloom fresco Instructions D'installation page 26

(c6) Seat unit recline
– In highchair mode the seat unit shall always
be adjusted to the vertical upright position.
– Adjust the seat unit to the vertical upright
position by pressing the handle on the rear of
the seat unit, then raise the seat upwards to
the highest position, then release the handle.
You will hear an audible click. Check the seat
unit is locked in position by moving it.
WARNING:
Highchair mode is designed for children from
approximately 6 months (must be able to sit
up unaided) to 6 months only. Always use
the safety harness.
WARNING:
Always be sure your child is clear of moving
parts before making any adjustments.
Toddler chair mode
– suitable for 6 months to 6 kg/79
lbs (refer to Section d of Illustrations)
(d-d5) Without safety bar
Seat pad assembly
– (#09) Pull open the storage compartment
door located on the inner face of the seat
unit.
– (#11) Remove the comfort nest attachment
part from the storage compartment by
unscrewing the two screws with a philips
head screwdriver.
– Keep the comfort nest attachment part and
All manuals and user guides at all-guides.com
– (#16, #17) From storage compartment, take
– (#03) Place the seat pad onto seat unit.
– Snap the 'U' shaped clips on either side of the
– Slide the crotch strap cover into the seat unit.
(d6-d) With safety bar
Seat pad assembly
– (#09) Pull open the storage compartment
– (#11) Remove the comfort nest attachment
– Keep the comfort nest attachment part and
– Close the compartment door.
– (#03) Place the seat pad onto seat unit.
– (#07) Remove the crotch bar comfort nest lock
– Keep the crotch bar comfort nest lock and the
– (#06) Place left & right "U" shaped bar clips
– Slide the crotch bar base into the seat unit.
– (#12, #13) If you would like to use the mini tray
the screws in a safe place for future use.
out the two 'U' shaped clips and the crotch
strap cover. Close the compartment door.
seat unit; you will hear an audible click.
door located on the inner face of the seat unit.
part from the storage compartment by
unscrewing the two screws with a philips
head screwdriver.
the screws in a safe place for future use.
from the base of the crotch bar by unscrewing
the two screws located on the bottom with a
philips head screwdriver.
screws in a safe place for future use.
located on either side of the safety bar onto
the side posts and lock into position. You will
hear an audible click.
and food tray with the toddler chair mode,
please refer to the assembly instructions
given in section C10-C14 of this user guide.
eng
9