Black & Decker BDPS200 Mode D'emploi page 12

• Clean the spray nozzle, pickup tube and
filter, atomizer, piston and spring with the
cleaning brush in the appropriate cleaning
solution (figure K8).
• Thoroughly clean the inside of the piston
chamber with the cleaning brush (figure K9).
IMPORTANT: Be sure to remove all material
from inside of piston chamber. A small amount
of material that is not removed with the
cleaning brush can harden over time and
interfere with the movement of the piston
causing damage to the sprayer.
• Thoroughly clean the inside of the intake
and return openings with the cleaning brush
(figure K10).
IMPORTANT: Also thoroughly clean the
smaller vent hole, shown with an arrow in
figure K11, with included cleaning pin.
• Dry all parts thoroughly.
• Slide the spring onto the front of the piston
(figure L).
• Insert the piston and spring into the front
housing (figure L1).
• Pressing down on the release button, insert
the front housing with piston, into the sprayer
until the release button pops into place
(figure L2).
NOTICE: The unit will not reassemble with-
out the piston and spring in place.
• Place a few drops of oil through the cylinder
opening. Insert the atomizer valve into the
front housing. Thread the spray nozzle onto
the front housing and hand tighten (figure L3).
K8
All manuals and user guides at all-guides.com
K10
REASSEMBLY
L
L2
12
K9
K11
L1
L3