Publicité
Les langues disponibles
Les langues disponibles
• Maintain smooth and consistent speed which will help avoid inconsistencies. Begin spraying after the pass has
begun and release trigger before stopping the pass.
• Avoid spraying too heavily in any one area. Several lighter coats are better than one heavy coat which can lead to
running and dripping. Remember that the flow control knob regulates the amount of liquid that can be sprayed. Turning
the flow knob counterclockwise increases the flow of liquid. Turning the knob clockwise decreases the flow of liquid. If
runs or drips do occur, have a dry paint brush on hand to smooth them out.
ELECTRIC SHOCK HAZARD. When spraying overhead, never tip the sprayer more than
45 degrees. The material being sprayed could leak into the motor housing.
WARNING:
TIP: If the atomizer valve is not seated prop-
erly, spray material will leak from behind the
spray nozzle. If
material is leaking, turn off and unplug
sprayer from power source immediately.
Follow these steps to correct the problem:
• Check that the sprayer is unplugged from the
power source. Remove the spray nozzle by
turning counterclockwise (figure J). For the fan
nozzle, remember to push and turn counter-
clockwise to remove.
• Remove the atomizer and check to see if it
needs to be cleaned or replaced. Also check
inside the pump housing for any debris or
obstruction and clean if necessary (figure J1).
• Replace the atomizer valve making sure it
seats properly (figure J2).
• Thread the spray nozzle back onto the
sprayer by turning clockwise
(figure J3).
WARNING:
• Make sure clean up area is well ventilated and free of flammable vapors.
Be sure to use appropriate protective gear.
• Always spray outdoors when spraying cleaning solution through sprayer.
• Use drop cloths during pouring, mixing, and viscosity testing of materials to be sprayed to protect your floors and
anything else in the spraying area that you wish to remain untouched.
TO BEGIN CLEANING:
• Unplug the sprayer from the power source.
• Unscrew the lid from the side of the canister
and pour any remaining liquid back into the
original container (figure K).
• Pour a small amount of the appropriate
cleaning solution into the canister (figure K1).
• Warm soapy water for water based
materials
• Manufacturers recommended cleaning
solution for oil based materials
• Replace the lid on the canister securely and
vigorously shake the sprayer.
All manuals and user guides at all-guides.com
J
J2
CLEANING
K
10
J1
J3
K1
Publicité
