Ayce 1314 Traduction De La Notice Originale page 80

Material
Hardwood
(Beech)
Softwood
(Pine)
(Pine)
Plastic
1-2 The values shown in the chart are standard values. The necessary speed depends
on the material and the operating conditions, and can be determined by practical
testing.
After longer periods of working at low speed, allow the machine to cool by running for
approx. 3 minutes at maximum speed with no load.
g. Mount guide bushing (Fig.7)
Fig. 7
Router Speed stages
4-10 mm 5-7
12-20 mm 3-4
22-40 mm 1-2
4-10 mm 5-7
12-20 mm 3-6
22-40 mm 1-3
4-10 mm 3-7
12-20 mm 2-4
22-40 mm 1-3
2-3
4-15 mm
16-40 mm 1-2
1. The guide bushing enables template
and pattern routing on work-pieces.
2. Detach the two screws on the
bottom and fix guide bushing in the
bottom of the base plate with the
two screws.
3. Lay the router with the guide
bushing against the template.
4. Switch on the router. Loosen l
plunge lock lever and slowly lower
the router to the work-piece,
until the adjusted depth-of-cut is
reached. Tighten plunge lock lever.
5. Lead the router with projecting
guide bushing along the template,
with light sideward pressure.
Note: Choose a router bit with a smaller
diameter than the inner diameter of the
guide bushing. The diameter of blade