Removing the collected water
There are two ways to remove collected water.
1. Use the bucket
When the unit is off,if the bucket is full, the unit will
beep 8 times and the Full indicator light will flash, the
digital display shows P2.
When the unit is on, if the bucket is full, the compressor
,
turns off and the fan turns off after 30 seconds for drying
the water then the unit will beep 8 times and the Full
indicator light will flash, the digital display shows P2.
Slowly pull out the bucket. Grip the left and right
handles securely, and carefully pull out straight so
water does not spill. Do not put the bucket on the floor
because the bottom of the bucket is uneven. Otherwise
the bucket will fall and cause the water to spill.
Pour out the water and reinstall the bucket. The bucket
must be in place and securely seated for the
dehumidifier to operate.
The machine will re-start when the bucket is restored
in its correct position.
NOTES:
When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product.
Be sure to push the bucket gently all the way into the
unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to operate.
When you remove the bucket, if there is some water in
the unit it must be dried.
2. Continuous draining
Water can be automatically emptied into a floor
drain by a ttaching the unit wi th a water hose
(I.D.
8mm
(5/16˝)
,not included) with a female threaded
end (I.D.
26mm
(1˝)
,not included).
Make sure
the drain hose is onto the adaptor A (See Fig.7,
placed in the bucket).
Remove the plastic cover from the back drain outlet of
the unit and remove bucket,then insert the drain hose
through the drain outlet of the unit and securely press it
onto the connector on the front of the unit.(See.Fig.9)
Tighten the adaptor A and the unit by using two screws
(placed in the bucket).
Install the female threaded end of the water hose
(not included)
the adaptor A.(See.Fig.10),then lead the
water hose to the floor drain or a suitable drainage
Make sure the hose is secure so there are no leaks.
Direct the hose toward the drain,making sure that
there are no kinks that will stop the warter flowing.
Place the end of the hose into the drain and make sure
the end of the hose is level or down to let the water flow
smoothly.
Make sure it is not pointing upwards.
Place the bucket back in the unit and make sure
that it is located correctly.
Select the desired humidity setting and fan speed
on the unit for continuous draining to start.
NOTE: When the continuous drain feature
is not being used,remove the drain hose
from the outlet.
OPERATING THE UNIT
opening.
8
1. Pull out the bucket a little.
2. Hold both sides of the bucket
evenly, and pull it
the unit.
3. Pour the water out.
Drain hose
Plastic cover
Drain hose
subassembly
Connector
Drain hose
Water hose
Female threaded end
Fig.5
out from
Fig.6
A
Adaptor
Fig.7
Fig.8
Fig.9
d
Fig.10