Publicité
Les langues disponibles
Les langues disponibles
16. Once license plate and Camera are secure, you can adjust the vertical angle of the Camera to your
specific need.
17. As a last check, note the position of the view from the Camera when you place the vehicle in reverse.
Adjust the angle of the Camera as necessary to achieve the best rear view.
Video's are available on www.letsyada.com to see step by step installation instructions.
DIESEL INSTRUCTION:
Temporarily connect the Camera following the wiring instructions above. Then check the Camera image
for rolling lines with vehicle running. If there are no rolling lines, permanently install the components
and wiring. If rolling lines occur you will need to run a power wire directly to the battery post instead of
using the reverse lights. Then the power line will need to be cut and run to a switch near the driver so the
Camera can be switched on/off. Without a switch the Camera would drain the battery and possibly burn
out the Camera. Be sure to use a fuse when connecting to the battery post.
6
Publicité
