Publicité
Les langues disponibles
Les langues disponibles
2)
Turn on the machine by pressing the line button
the water to come out of the rinse arms.
Caution: if the tank door is not closed, the machine will not charge the water, so check the door
by looking inside the machine baskets outlet.
the machine, open one of the machine doors, and at the same time press buttons C and D for a few seconds
until the wording Key 00 appears.
4)
Go to Key 01 by pressing button C and confirm with D.
5)
The wording QUIK READY NO will appear afterwards. Press C to change the status to Yes.
Keep the line button
and the quick heating will be activated. Lastly, wait until the machine is completely filled
4.7 Adjusting the controls
The table below indicates the requirements and default settings of the dishwasher:
minimum washing temperature
minimum rinsing temperature
intensive washing program (speed 1)
quick washing program (speed 2)
Filling hose
Max. incoming water temperature
Min. incoming water pressure
Max. incoming water pressure
Water hardness (recommended)
Water flow rate
For viewing the temperatures and operating times:
By keeping the C button pressed for approximately 4 seconds, the instant temperature of the booster and of
the tank can be viewed. The number of daily hours and of the machine's working totals of the machine's life
will also run across the display.
3)
Now the booster tank should be full, so start the quick heating of the booster. Turn off
pressed until you see this again:
170 °F (75°C)
190 °F (88°C)
150 racks/h
200 racks/h
26.4 mm (3/4")
140 °F (60 °C)
100 kPa (14.5 psi)
345 kPa (50 psi)
6 (French degrees)
20 l/min. (5.3 gpm)
and the machine will start to charge water. Wait for
6
. Then re-start the machine
.
Publicité
