Publicité
Les langues disponibles
Les langues disponibles
GB
INSTRUCTION ON MOUNTING AND USE
Check also the drawings on the initial pages with the alphabetical
and numerical references in the explanatory text.
Closely follow the instructions in this manual. We cannot
accept liability for any faults, detriment or fire damage to the
appliance due to non-compliance with the manual's
instructions. Installation and electrical connections must be
executed by a qualified technician. You should affix the hood
to a wall of sufficient weight-bearing capacity, so not to one
made of plasterboard. Do not install it inside a cupboard.
Attach it to the wall using the anchors provided:Pag.2( Fig. 3
diameter 12, Fig. 6 diameter 8) Pag.3 (Fig. 4 diameter 10)
Installation
The cooker hood must be placed at a minimum distance of 65
cm from the cooking plane for electric cookers and 75cm for
gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater
distance, this has to be taken into account.
Do not tile, grout or silicone this appliance to the wall. Surface
mounting only. Do not fix chimney flue to furniture or fly over
shelves unless the chimney flue can be easily removed, in
case maintenance is ever required.
Use
The cooker hood is provided with an upper air exit B for
discharging fumes externally for models including chimney
flue C ( Suction Version A- exhaust pipe not supplied).
If cooking fumes and vapours cannot be externally discharged,
the cooker hood can be used in the recirculating version
F: the installation of 1 active charcoal filter F allows the
recirculation of fumes and vapours through the upper grid G.
Electrical connection
Make sure that there is a power socket near the hood and
that the system has a 30 mA differential. The mains voltage
must be the same as that on the label inside the hood. The
hood has a 1250 mm power cable with or without plug: if it
does have a plug, connect the hood to an accessible
approved socket; or if it does not (connection direct to the
mains), fit an approved bipolar switch with a minimum
contact opening of no less than 3 mm (accessible). This
installation and electrical connection must be executed by a
qualified technician.
Operation
A
B
A: ON/OFF light switch: the hood light turns on or off when
the button is pressed.
C: ON/OFF fan button (4 speeds): on touching the switch
on the hood, it starts up at the same speed at which it was
turned off at and by pressing the „+" and „-" you can change
the suction speed (power).
B: Button to reduce the suction speed (power): the hood's
suction speed is reduced when you touch the button.
D
E
C
D: button to increase suction speed (power): the hood's
suction speed is increased when you touch the button.
E: Timer button: the timer function comes on when the button
is pressed no matter what the selected suction speed is. The
timer will run for 5 minutes when the button is initially pressed;
each time the button is pressed after this, the duration will
increase by 5 minutes up to a maximum of 15 minutes. Press
the fan button to reset the timer.
At this stage, the lit instructions will flash the colour of the speed
selected.
Lit instructions: the lit instructions projected onto......., vary
in colour and frequency according to the operating method and
suction speed selected:
First speed: green
Second speed: orange
Third speed: red
Intense: sequence of three colours
Sensor function: the sensor is activated by simultaneously
pressing the „+" and „-" buttons. In this mode, the suction
speed is automatically calibrated. Press the „+" or „-" buttons
to return to the manual function. At this stage, the lit instructions
will flash red and green intermittently.
Acoustic signal: each time contact is made with any of the
buttons, the hood gives off a small acoustic signal as
confirmation.
Maintenance
Prior to any maintenance operation ensure that the cooker hood
is disconnected from the electrical outlet.
Cleaning:
The hood must be cleaned frequently both inside (apart from
the area behind the grease filter) and outside. Use a cloth
moistened with denatured alcohol or neutral liquid detergents.
Never use products containing abrasives.
Warning: Failure to carry out the basic standards of the cleaning
of the cooker hood and replacement of the filters may cause fire
risks. Therefore we recommend observing these instructions.
Anti-grease Filter – must be cleaned once a month, with non
abrasive detergents, by hand or in dishwasher on low temperature
and short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
Charcoal Filter - (only for filter version):
The active charcoal filters F are not washable nor regenerative.
It should be changed every 6 months in normal use.
The active charcoal filters capture unpleasant cooking odours.
7
Publicité
