Remington HEDGE WIZARD 110946-01 Mode D'emploi page 8

ELECTRIC POLE TRIMMER
TROUBLESHOOTING
Note: For additional help, visit our
technical service web
www.desatech.com.
OBSERVED FAULT
Motor does not run when you squeeze trig-
ger lever
Motor runs, but cutting blades do not move
Pole Trimmer smokes during operation
SERVICING POLE
TRIMMER
The Pole Trimmer is a double-insulated tool
and contains some parts that can only be
replaced with original parts by an Autho-
rized Service Center. Visit our Technical
Service web site at www.desatech.com
or contact our Technical Service Depart-
ment at 1-800-858-8501 (English Only) for
the nearest Authorized Service Center.
The parts listed on pages 10 and 11 are
considered to be user replaceable. See Re-
placement Parts and Accessories, page 9,
for information on ordering these parts.
BLADE REPLACEMENT
WARNING: To prevent seri-
ous personal injury, wear gloves
when removing and installing the
cutter blades. Do not place fin-
gers or hands between blades
where they could get cut.
For more information, visit www.desatech.com
All manuals and user guides at all-guides.com
®
WARNING: Unplug Pole Trimmer from power source before servicing.
Severe injury or death could occur from fire, electrical shock, or body
contact with moving blades.
site at
POSSIBLE CAUSE
1. Trigger lock button not pressed to release
trigger lever
2. Extension cord connection is loose
3. Household circuit breaker is tripped or
open line fuse
4. Bad motor brushes
5. Open wiring on Pole Trimmer
Pole Trimmer damaged. Do not use Pole
Trimmer
Pole Trimmer damaged. Do not use Pole
Trimmer
1. Unplug pole trimmer from power supply.
2. Place pole trimmer upside down on
workbench and remove the four (4)
bottom cover screws. Lift bottom cover
off (see Figure 17).
Figure 17 - Removing Bottom Cover from
Trimmer Head
REMEDY
1. Push lock button forward and squeeze
2. Check cord connections
3. Check circuit breaker or line fuse
4. Call for Technical Service
5. Call for Technical Service
Call for Technical Service
Call for Technical Service
3. Remove the two 5/16" nuts closest to
4. Rotate cam so that cam and cutter blade
Cover Screw
Bottom Cover
Cam Cover
Cam
Figure 18 - Removing Cam Cover
8
trigger lever (see Starting the Pole Trim-
mer, page 5)
the power head and lift off cam cover
(see Figure 18). These parts will be in-
cluded with the new cutter blade and
will not be needed.
assembly slot are aligned (see Figure 18).
5/16" Nut
Cutter Blade Assembly
Washer
110939