Remington HEDGE WIZARD 110946-01 Mode D'emploi page 5

OPERATING POLE
TRIMMER
Continued
3. Create a loop in the extension cord and
insert the loop through the bottom of
the handle. Pull the loop tight around
the molded cord hook (see Figures 6
and 7).
Figure 6 - Inserting Extension Cord Loop
Through Bottom of Handle
Figure 7 - Extension Cord Loop Tight
Around Molded Cord Hook
110939
All manuals and user guides at all-guides.com
Note: An optional method of retaining the
extension cord is shown in Figure 8 for use
with larger-gage cords that may not fit into
the extension cord retainer.
Figure 8 - Optional Method of Retaining
Extension Cord
STARTING THE POLE
TRIMMER
The Pole Trimmer has a trigger lock button
located on top of the handle. This safety
feature locks the trigger in the OFF position,
preventing accidental starting of the Pole
Trimmer.
The trigger lock button has three positions.
Position 1 locks the trigger.
Position 2 allows you to squeeze the trig-
ger and operate the Pole Trimmer. The trig-
ger lock button will automatically spring
back to Position 1 when you release the
trigger.
Position 3 allows you to lock the trigger in
the ON position. This is helpful during con-
tinuous trimming for extended periods
of time.
5
OWNER'S MANUAL
Unlocking the Trigger to Start
the Pole Trimmer
1. Using your thumb, push the trigger lock
button forward to Position 2. Squeeze
the trigger lever to the ON position. The
Pole Trimmer will start running.
Figure 9 - Manually Operating Trigger
with Trigger Lock Button in Position 2
2. Release the trigger lock button while the
Pole Trimmer is running. The lock but-
ton resets to Position 1 each time you
release the trigger to the OFF position.
Figure 10 - Trigger in OFF Position with
Trigger Lock Button in Position 1
For more information, visit www.desatech.com
Trigger Lock
Button Position 2
Trigger Lock
Button Position 1
Continued