Belkin TuneTalk F8Z082 Mode D'emploi page 3

Using the TuneTalk Stereo
To select the recording quality:
From the iPod menu, select "Extras > Voice Memos > Quality". Pressing the "Select" button will
toggle between Low (22.05kHz, mono) or High (44.1kHz, stereo).
To record:
1. Connect the TuneTalk to the bottom of the iPod video. The iPod video will launch the
"Record" function when you do this. With the "Record" option highlighted, press "Play/
Pause" or press the "Select" button to begin recording. To pause recording, press "Play/
Pause" again or highlight "Pause" and then press the "Select" button on the iPod video.
2. During recording, there are two options: "Pause" and "Stop and Save". To end a recording,
either press the "Menu" button or highlight the "Stop and Save" option, and then press the
"Select" button. This saves your recording and lists it by date and time recorded.
NOTE: After stopping a recording, the recording LED remains on until the recording is saved to
the iPod.
3. To begin another recording, go to the top of the "Voice Memos" menu and select "Record
Now"; or, from the iPod menu, select "Extras > Voice Memos > Record Now". Or simply press
the "Quick Memo" button on the TuneTalk Stereo.
NOTE: For personal memos or notes, hold the iPod video with the TuneTalk Stereo attached
six to 18 inches from your mouth and speak in a normal tone. Holding the device too close or
speaking too loudly may degrade the quality of your recording.
All manuals and user guides at all-guides.com
Using the TuneTalk Stereo
En
| 02