Publicité
Les langues disponibles
Les langues disponibles
127859
Running in the engine
•
When the tool is new only run the engine at moderate speed.
•
Do not maintain high engine speed until the engine is fully run in.
•
The engine will not be capable of developing maximum power until the
end of the running in period.
•
When first using the tool, stop and make sure that all nuts and screws
are securely fastened and tighten them as necessary.
•
Do not use fuels containing methanol, or ethanol, as these may cause
internal damage to the fuel tank, and fuel lines.
Servicing
•
It is recommended that you get your tool serviced shortly after its first
use.
•
In normal use, have the tool serviced regularly.
•
Do not attempt to alter any of the components of this tool. To do so
would not only invalidate your guarantee, but may also result in injury to
yourself, or others around you.
•
Always have your tool serviced at an authorised service centre.
Storage
•
When you have finished using the tool, clean it completely.
•
Be careful not to hit or cut the fuel tank, or fuel lines, when it is placed
on the ground.
•
Do not let the tool fall, or it may be damaged and become unsafe.
•
Store the tool away from direct sunlight.
•
Ensure that fuel and oil is stored in a safe place, away from heat, direct
sunlight, any source of ignition, and out of reach of children.
Whenever the machine is out of use for an extended period
of time, proceed as follows:
•
Empty the fuel tank completely.
•
Protect all metal engine parts from corrosion by coating them with oil.
•
Remove the spark plug, put a few drops of oil into the cylinder and then
pull the recoil starter 2 to 3 times in order to distribute the oil evenly.
Replace the spark plug.
Never leave the tool running unattended
•
Always wait until the machine has come to a complete stop before
leaving it.
•
Never leave the machine unattended when parts are still hot.
•
Never leave machine unattended where children, may have access to it.
THIS PRODUCT PRODUCES POISONOUS EXHAUST FUMES
AS SOON AS THE ENGINE IS RUNNING. THESE GASES MAY
BE COLOURLESS AND ODOURLESS. TO REDUCE THE RISK
OF SERIOUS OR FATAL INJURY, NEVER RUN THE MACHINE
INDOORS, OR IN POORLY VENTILATED AREAS. ENSURE
PROPER VENTILATION WHEN WORKING IN TRENCHES OR
OTHER CONFINED SPACES.
Hedge Trimmer Safety
•
Always check the work area for hidden objects, fencing, cables etc. Be
sure that it is safe to cut before beginning a job.
•
Always wear appropriate safety equipment. Use of this tool requires the
use of gloves, eye or face protection, and sturdy clothing.
•
If the hedge trimmer becomes jammed, switch off immediately. Unplug
the hedge trimmer from the power supply before attempting to clear
jammed material.
•
Do not use this product in wet conditions. Ensure that material to be cut
is dry before starting work.
•
Take care to keep the power lead away from the cutting area. Cutting
through the power lead may cause an electric shock.
•
Always keep cutting blade properly lubricated, keep covered when not
in use.
127859_Manual.indd 5
All manuals and user guides at all-guides.com
Petrol Hedge Trimmer 22cc
Product Familiarisation
1
Blade
2
Guard
3
Front handle
4
Starting handle
5
Ignition switch
6
Throttle trigger
7
Safety switch
8
Rear handle
9
Fuel filler cap
10 Choke lever
11 Air filter cover
12 Priming bulb
13 Spark plug
www.silverlinetools.com
5
1/4/10 17:34:16
Publicité
