Grandstream GHP610 Guide D'installation Rapide page 4

GHP610/W & GHP611/W DESCRIPTION:
MPK Sticker
Flash
Speaker
Volume Down Key
Mute Indicator
Microphone
LAN Port
Note: The LED for the message waiting indicator will 昀氀ash in
green when there is a message waiting.
WALL MOUNT:
On the wall where the GHP610/W &
•
GHP611/W will be mounted, mark two dots
with 100mm distance in between vertically.
Using a drill, make a hole on each marked
•
dot. Put a plastic expansion bolt and screw
(not provided) into each hole. Leave enough
space on the screws to mount the GHP610/W
& GHP611/W.
Mount the GHP610/W & GHP611/W on the
•
screws using its "Wall Mount Slots".
~ 3 ~
Softkeys
Alphanumeric Keypad
Message
Redial
Hold
Volume Up Key
Mute
RJ11 Port
Power
Handset Port
INSTALLING SPEED DIAL LABEL:
1. Handwrite or print the names on the dedicated space on the
paper label.
2. Place the paper label in the groove of the phone.
3. Bend the plastic 昀椀lm so that the protruding points on the left
and right sides can snap into the grooves.
Note: To remove the 昀椀lm, use a nail or thin card to move the slit
on one side of the 昀椀lm to bend it and then take it out.
Message
Waiting
INSTALLING MPK LABEL:
Indicator
Wall
mount
slots
CONNECTING THE PHONE:
100mm 100mm
To set up the phone, follow the steps below:
1. Plug in the phone cord to the handset RJ11 port and then
connect it to the base.
Wall
mount 2. Connect the LAN port of the phone to the RJ45 socket of
slots
a hub/switch or a router (LAN side of the router) using the
Ethernet cable. This step can be skipped if using GHP610W
& GHP611W with Wi-Fi.
Scan the QR code to
watch the speed dial
installation and con昀椀gura-
tion video guide
1. Remove the MAC address
sticker from the front of the
handset.
2. Remove the release paper
from the back of the MPK
label.
3. Stick the MPK label on the
indicated area. Please refer to
the illustration on the left.
~ 4 ~