Doro HearPlus 325a Mode D'emploi page 18

Using with TV (connection via scart socket)
Very useful for listening to the TV and being able to adjust the volume yourself. This method removes all
unwanted noise from the surroundings and gives others listening the possibility to adjust the volume.
1. Set up as described in Preparation.
2. Place the transmitter close to the TV and connect it with the scart cable supplied to the TV's scart socket and
the stereo cable (3.5 mm) to the transmitter. Normally AV2 should be used on the TV.
3. Adjust volume and tone as required.
Important!
The scart socket is normally located on the back of the television. The scart adapter has double sockets so that other
units can be connected to the same scart outlet.
Using with a mobile phone
Registration
The receiver unit must be registered manually to the mobile phone with which it is to be used. The mobile phone's
user guide will show you how to register/match a Bluetooth headset.
To set the receiver in register mode follow these instructions.
1. Check that the charger is disconnected and that the receiver is switched on (see Turning Off/On).
2. Press straight in and hold for approximately 3 seconds.
3. Move upwards and hold there for approximately 3 seconds. Release ; the indicator to the right will now
start to flash slowly.
4. Follow instructions in the other equipment's user guide for registration/matching of a Bluetooth unit/headset.
The receiver will be shown as OdicioHS1 in the equipment's display (where there is one). Then enter the
receiver's code 4 3 2 1 if the equipment asks for it.
5. When registration is successful the indicator will flash (briefly) green about every four seconds.
Important!
Registration mode lasts for about 3 minutes.
If registration to a mobile phone should not succeed, repeat steps 1-5.
All manuals and user guides at all-guides.com
English
1