Publicité
Les langues disponibles
Les langues disponibles
DFSE :
•
Enter this sub-menu to reset the device to factory default.
(Reload the values shown in
STROBE CH :
Enter this sub-menu to select the behavior of the strobe channel:
•
[ON] - LEDs are ON when the strobe channel is at 0.
•
[OFF]
- LEDs are OFF when the strobe channel is at 0.
INFO
[Time.Info] - Usage Time
•
[Current] : Display of usage time (in hours) since last power-on.
•
[TotalTime] : Display of usage time (in hours).
•
[Last] : Display of the time of use (in hours) since the last time reset.
•
[PASSWORD] : To access the usage time reset, you must enter a
PIN code: 050 to reset [Last] value.
[Clear] : [ON] to reset [OFF] to cancel
[Temp.Info] - Temperature display
•
[LED temp] : xxx F or C - LED temperature display
[Err.Info] - sensor errors
•
[None] : No error
•
[Zoom] : Zoom Sensor error
•
[Temp] : LED temperature sensor error
[ModelInf] - Displaying the projector model [ParKolor 200 DW]
[Software] - Firmware version display [Vx.xxx]
MANUAL :
[Reset.M] - Enter this sub-menu to reset the Zoom.
[ManCtrl] - Manual control
Allows you to create a luminous state. Adjust the following parameters to create a state.
Validate with [Enter] each parameter.
•
[Dimmer] : from 000 to 255 adjust overall Intensity.
•
[Strobe] : from 000 to 255 adjust the Strobe.
•
[Zoom] : from 000 to 255 adjust the Zoom.
•
[CCT] : from 000 to 255 adjust Color temperature.
NB :
Zoom and CCT settings are also used for 1ch, 2ch, 3ch CCT and 4ch DMX modes.
[Calibrate]
Sub-menu allowing to recalibrate the various parameters of the ParKolor 200 DW.
To access this menu, you must enter the PIN code to unlock this function.
Pin Code : 050
This gives access to the various parameters.
•
[Zoom] : de 000 à 255 calibrate the Zoom.
•
[CWhite] : de 000 à 255 calibrate Cold White.
•
[WWhite] : de 000 à 255 calibrate Warm White.
red
in the menu structure)
Page 29
Publicité
