König N-CSBTTRNSM100 Mode D'emploi page 3

3. After being connected for the first time, the two devices will recognise each
other next time.
Connect the second set of headphones or music receiver:
1. Take the second set of Bluetooth® headphones or Bluetooth® music
receiver.
2. Press the pairing button (check the device manual).
3. Press the pairing button on the CSBTTRNSM100 once for approx.
1 ~ 2 seconds. The LED light starts blinking while the transmitter searches
for the second set of headphones or music receiver. The device that was
connected first, is muted.
4. If the devices are connected, the LED light is constantly switched on.
Note
The CSBTTRNSM100 features the option to connect two Bluetooth® A2DP
devices at the same time. If you would like to connect a second A2DP device,
you need to reset the CSBTTRNSM100 to establish a new connection.
Reset
Press the pairing button on the CSBTTRNSM100 and release it again. The LED
light on the CSBTTRNSM100 starts blinking while the transmitter is searching
for A2DP devices nearby.
LED indication
Indication
Flash every 5 seconds
Constantly switched on
Troubleshooting
If you do not hear any sound coming from your headphones or music receiver,
check the following:
- make sure the CSBTTRNSM100 is powered;
- make sure the audio cable is correctly connected to the CSBTTRNSM100;
- make sure that the audio source is working properly;
- make sure the volume of the audio source is set correctly;
- make sure your device is at a maximum distance of 10 metres of the audio
transmitter.
Meaning Description
Pairing Searching for a device in pairing mode
Connected CSBTTRNSM100 and device are
connected
3
ENGLISH